Procedure
Description
Qty.
Use
Bolt (1/2 x 3-1/4 inch)
1
15
Locknut (1/2 inch)
1
Install the ROPS hardware (LPG
machines only).
16
Roll-Over Protection System (ROPS) Kit
1
Install the ROPS (International
machines using gasoline only).
Roll bar, right section
1
Roll bar, left section
1
Roll bar, center section
1
Bolt (3/8 x 1 inch)
8
Curved washer
8
Flange nut (3/8 inch)
8
Bolt (1/2 x 3–1/4 inch)
2
17
Flange nut (1/2 inch)
2
Install the ROPS (Diesel machines
only).
18
Number 2 general-purpose lithium-base
or molybdenum-base grease. (Purchase
separately.)
1 tube
Check the machine for grease.
19
No parts required
–
Remove the shipping straps.
20
No parts required
–
Check the machine before delivery to
the customer (All machines).
Operator's Manual
1
Engine Owner's Manual
1
Registration card
1
Operator-training material
1
21
Key
2
Delivering the machine to the customer
(All machines).
1
Removing the Machine from a
Crate
Parts needed for this procedure:
2
Rear wheels (Wooden crate only)
Removing a Machine from a Metal Crate
If removing the machine from a metal crate, refer to the
Dealer/Distributor Portal
for further information.
Removing the Machine from a Wooden
Crate
1.
Remove the screws holding the right angle retaining
plate to the crate.
Figure 1
Gasoline Machine Shown
Figure 2
Diesel Machine Shown
2
