Toro Z Master Professional 7500-D Series, Operator'S Manual

Page: 53 / 80

Drive System
Maintenance
Checking the Seat Belt
Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Adjusting the Tracking
1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the
motion-control levers to the N
EUTRAL
-L
OCK
position.
3. Move the throttle midway between the F
AST
and
S
LOW
positions.
4. Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. Engage the parking brake, shut off the engine,
and remove the key.
7. Adjust the stop plates as needed.
•
If the machine tracks to the right, loosen the
bolts and adjust the left stop plate rearward
on the left T-slot until the machine tracks
straight (
Figure 51 ).
•
If the machine tracks to the left, loosen the
bolts and adjust the right stop plate rearward
on the right T-slot until the machine tracks
straight (
Figure 51 ).
8. Tighten the stop plate ( Figure 51 ).
g254284
Figure 51
1. Control lever 3. Stop plate
2. Bolt
9. Align the levers in the front-to-rear position by
bringing the levers together to the N
EUTRAL
position, and slide them until they are aligned,
then tighten the bolts (
Figure 52 ).
g009195
Figure 52
10. If alignment is needed, loosen the 2
motion-control lever mounting bolts on the
misaligned side (
Figure 53 ).
g254283
Figure 53
11. Move motion-control lever to meet the opposite
side.
12. Tighten the 2 motion-control lever mounting
bolts (
Figure 53 ).
53