Toro Z Master Professional 2000 Series, Setup Instructions

Page: 4 / 12

7
Raising the Rollover
Protection System (ROPS)
No Parts Required
Procedure
1. Pull both knobs out and rotate them 90 degrees
so that they are not engaged (
Figure 3 ).
2. Raise the roll bar to the operating position and
rotate the knobs until they move partially into
the grooves (
Figure 3 ).
g035064
Figure 3
1. Roll bar in the upright position
2. ROPS knob in the latched position
3. Pull the ROPS knob out.
4. Rotate the ROPS knob 90 degrees.
5. ROPS knob in the unlatched position
3. Raise the roll bar to the full upright position while
pushing on the upper roll bar so that the pins
snap into position when the holes align with the
pins.
4. Push on the roll bar and ensure that both pins
are engaged (
Figure 3 ).
4