4. Align the center hole over the mounting pin that
points straight up on the mower as shown in
Figure 3.
G013619
Figure 3
1.
Tank collar
3.
Center hole
2.
Mounting pin
Important:
Valves and gauges may not function
properly if the LPG tank is not installed
correctly.
5. Latch the brackets and make sure the tank is securely
fastened to the mower.
6. Carefully connect the fuel hose. Make sure the hose
is not kinked.
7. Slowly open the fuel valve to equalize the pressure in
the tank. If the fuel valve is opened too quickly, the
pressure relief valve is equipped with a back pressure
check valve that will shut off the fuel supply. If this
happens, close the fuel valve completely and wait
five seconds. Slowly open the fuel valve.
g013437
1
2
3
Figure 4
1.
LPG fuel hose connection
fitting
3.
Fuel gauge
2.
Tank valve
8. Check for leaks as described in the Safety section
of the Operator’s manual.
6
Installing ROPS Hardware
Parts needed for this procedure:
1
Bolt (1/2 x 3-1/4 inch)
1
Locknut (1/2 inch)
Procedure
Install the bolt (1/2 x 3-1/4 inch) and locknut (1/2 inch)
into the open hole in the ROPS (Rollover Protection
System) (Figure 5). This will prevent the roll bar from
hitting the cylinder when lowered to the down position..
3
