Toro Z Master 74902TE, Operator'S Manual

Page: 34 / 80

g027996
Figure 41
1. Full-width ramp in stowed
position 4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
2. Side view of full-width
ramp in loading position 5. H=height of the trailer or
truck bed to the ground
3. Not greater than
15 degrees 6. Trailer
Using the Z Stand TM
The Z Stand raises the front end of the machine to
allow you to clean the mower and remove the blades.
WARNING
The machine could fall onto someone and
cause serious injury or death.
• Use extreme caution when operating the
machine on the Z Stand.
• Use the Z Stand only for cleaning the
mower and removing the blades.
• Do not keep the machine on the Z Stand
for extended periods of time.
• Always shut off the engine, set the
parking brake, and remove the key before
performing any maintenance to the mower.
Driving up onto the Z Stand
Important:
Use the Z Stand on a level surface.
1. Raise the mower deck to the transport position.
2. Remove the bracket pin ( Figure 42 ).
g010172
Figure 42
1. Z Stand 4. Bottom of slot
2. Bracket pin 5. Latch
3. Bracket
3. Raise the latch.
34