Toro Workman MDE 2008, Service Manual

Page: 27 / 130

Workman MDE
Page 3 -- 11
Electrical System
Adjustments
Accelerator Switch Adjustment
1. Position vehicle on a level surface, turn on/off switch
OFF and remove key.
2. With the accelerator pedal released, check that the
distance between the head of the accelerator switch
stop cap screw and the body of the switch is 5/8 inch
(15.9 mm) (Fig. 12).
3. If distance is incorrect, loosen lock nut and adjust ac-
celerator switch stop cap screw position (Fig. 11).
4. After adjustment, make sure that switch plunger is
not bottomed out when accelerator pedal is released.
5. Calibrate accelerator system after adjusting acceler-
ator switch (see Accelerator System Calibration in this
section).
1. Accelerator pedal
2. Accelerator switch
3. Plate
4. Screw (2 used)
5. Switch stop cap screw
6. Lock nut
Figure 10
1
2
3
4
5
6
1. Accelerator switch
2. Switch stop cap screw
3. Accelerator stop cap screw
Figure 11
1
2
3
1. Switch stop cap screw 2. Accelerator switch
Figure 12
5/8 inch
(15.9 mm)
1
2
Electrical System