Toro Workman GTX, Operator'S Manual

Page: 21 / 52

Closing the Tailgate
If you unloaded loose material such as sand,
landscaping rock, or wood chips from the cargo box of
the machine, some of the material that you unloaded
may have lodged in the hinge area of the tailgate.
Perform the following steps before closing the tailgate.
1. Remove as much of the material from the hinge
area as possible.
2. Rotate the tailgate to approximately the 45°
position (
Figure 14 ).
g034023
Figure 14
1. Rotate the tailgate back
and forth several times. 3. Hinge area
2. Rotate the tailgate to
approximately the 45°
position.
3. Use a short, shaking motion to rotate the tailgate
back and forth several times (
Figure 14 ).
Note:
This action helps move material away
from the hinge area.
4. Lower the tailgate and check for material
remaining in the hinge area.
5. Repeat steps 1 through 4 until the material is
removed from the hinge area.
6. Rotate the tailgate up and lift the tailgate into the
notches in the cargo box.
Using the Rear Cargo Box
Accessory Mount
Use the rear cargo box accessory mount to attach
accessories to the rear of the machine.
Capacity: 45 kg (100 lb)
1. Loosen the “T” handle by rotating it clockwise
(
Figure 15 ).
g034545
Figure 15
1. Receiver 2. “T” handle
2. Insert your accessory into the receiver until the
holes align (
Figure 15 ).
3. Secure the assembled accessory to the receiver
tube using the clevis pin and hairpin cotter
supplied with the accessory.
4. Tighten the “T” handle by rotating it
counterclockwise (
Figure 16 ).
g034546
Figure 16
1. “T” handle
21