Toro WORKMAN GTX 07131, Operator'S Manual

Page: 40 / 48

Figure 45
1. Tie rod 2. Jam nut
5. Rotate both tie rods to move the front of the tire
inward or outward.
6. Tighten the tie rod jam nuts when the adjustment is
correct.
7. Ensure that there is full travel of the steering wheel in
both directions.
Checking the Transaxle-Fluid
Level
Service Interval: Every 100 hours
Fluid Type: SAE 10W-30 (API service SJ or higher)
1. Move the machine to a level surface, shut off the
machine, engage the parking brake, and remove the key.
2. Remove the fill plug on the transaxle ( Figure 46 ).
Figure 46
1. Drain plug 2. Fill plug
3. If the fluid level is low, remove the fill plug and add the
specified fluid until it runs out of the hole (
Figure 46 ).
4. Replace the fill plug and torque it to 20 to 27 N∙m (15
to 20 ft-lb).
Changing the Transaxle Fluid
Service Interval: Every 800 hours/Yearly (whichever comes
first)
Fluid Type: SAE 10W-30 (API service SJ or higher)
Fluid Capacity: 1.4 L (1.5 US qt)
1. Align a drain pan under the drain plug ( Figure 46 ).
2. Remove the fill plug and the seal ( Figure 46 ).
Note:
Retain the fill plug and seal for installation in
step 6 .
3. Remove the drain plug and the seal, and allow the fluid
to drain completely (
Figure 46 ).
Note:
Retain the drain plug and seal for installation
in step 4 .
4. Install the drain plug and seal, and torque it to 20 to 27
N∙m (15 to 20 ft-lb).
5. Fill the transaxle with the specified fluid until it runs
out of the fill hole.
6. Install the fill plug and seal, and torque it to 20 to 27
N∙m (15 to 20 ft-lb).
40