Toro wheel horse 315-8, Operator'S Manual, Page: 14 / 40

14
Attaching the Washer and
Hairpin Cotter onto the Lift Bar
Install a flat washer (1/2 x 1 in.) and a hairpin cotter
(1-7/8 in.) onto the lift bar (Fig 5).
2
1
3
m–2504
Figure 5
1. Lift Bar
2. Flat Washer, 1/2 x 1 in.
3. Hairpin Cotter,1-7/8 in.
Checking the Wiring and
Fasteners
•
Inspect the tractor for any loose electrical connections
and secure as required. Check the wire routing to make
sure no moving parts interfere with the wires to cause
a short.
•
Check all fasteners to make sure they are tight.
Checking the Engine Oil
Important The tractor is shipped from the factory with
oil in the engine crankcase
Check the oil level and add only enough oil to raise the
level to the full mark on the dipstick. Refer to Checking
the Engine Oil on page 24.
Learn to Operate the Tractor
Learn how to operate the tractor. Read the Operation
section starting on page 15.
Checking the Tractor
Lubrication
Check the tractor to ensure it is lubricated. Refer to
Greasing and Lubrication on page 26.
1. Check the oil level in the transaxle. Refer to Servicing
the Transaxle for oil type, viscosity and capacity on
page 29.
2. Check to make sure all lubrication points have been
greased. These points include the front axle pivot and
spindles, foot pedal(s) and steering gear.
Test Driving the Tractor
1. Fill the tank with unleaded regular gasoline with an
octane rating of at least 85. Open the fuel shutoff valve
and check the fuel hose and fittings for leaks.
2. As applicable, check and test the operation of the
following:
•
Engine, choke and throttle controls
•
Gauges
•
Headlights
•
Indicator lights
•
PTO clutch and brake
•
Lift system
•
Service and parking brakes
•
Transmission controls
•
Steering
•
Tractor operation in forward and reverse
Checking the Safety System
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
•
Do not tamper with the interlock switches.
•
Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Caution
Refer to Checking the Safety Interlock System on
page 17.