Toro Wheel Horse 270HE, Operator'S Manual

Page: 36 / 44

Maintenance
34
1
2
3
4
4
5
5
Figure 36
1. Bulb holder
2. Reflector
3. Tabs
4. Slots
5. Terminals
Installing the Bulb
1. The bulb has metal pins on the side of its base.
Align the pins with the slots in the bulb holder
and insert the base into the holder (Fig. 37).
Push and rotate the bulb clockwise until it stops.
1
2
3
4
2
4
Figure 37
1. Bulb
2. Metal pins
3. Bulb holder
4. Slots
2. The bulb holder has two tabs (Fig. 36). Align the
tabs with the slots in the reflector, insert the bulb
holder into the reflector and rotate it 1/4 turn
clockwise until it stops.
3. Push the wire connectors onto the terminals on
the bulb holder.
Battery
Service Interval/Specification
Check the electrolyte level in the battery before each
use. Always keep the battery clean and fully charged.
Use a paper towel to clean the battery case. If the
battery terminals are corroded, clean them with a
solution of four parts water and one part baking soda.
Apply a light coating of grease to the battery
terminals to prevent corrosion.
Voltage: 12 v, 280 Cold Cranking Amps
Removing the Battery
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
“OFF” to stop the engine. Remove the key.
2. Open the hood to see the battery.
3. Remove side panels for clearance when
removing battery (Fig. 39). Remove the wing
nuts and screws and lift up to clear pin and slide
panel tabs out from steering tower.
4. Disconnect the negative (black) ground cable
from the battery post (Fig. 38).
5. Lift the rubber cover up on the positive (red)
cable. Disconnect the positive (red) cable from
the battery post (Fig. 38).
6. Remove the battery hold down rods (Fig. 38).