Toro Wheel Horse 12-32 XL, Operator'S Manual, Page: 41 / 48

Maintenance
39
10. Now slowly rotate the right side slope adjusting
nut until both adjusting nuts are in the same
position.
IMPORTANT: If the slope adjustment does
not stay in position after you adjust it,
tighten the center bolt and lock nut and
repeat step 9.
Figure 46
1. Slope adjusting nut (left)
A = Down to raise mower
B = Up to lower mower 2. Bolt and lock nut
3. Mower pivot mount
B
A
1
2
3
1902
11. If the 0” to 1/4” (0 mm to 6.5 mm) front slope
cannot be achieved by rotating the slope
adjusting nut, move the mower pivot mount at
the mower (Fig. 47).
12. Remove the shoulder bolts and lock nuts from
the mower (Fig. 47).
13. Lower the mower pivot one hole and install the
shoulder bolts and lock nuts (Fig. 47).
Note: If your mower has only one hole, see
an Authorized Service Dealer.
14. Repeat front-to-rear blade slope adjustment; refer
to steps 8–10.
Figure 47
1. Mower pivot
2. Shoulder bolt
3. Lock nut
4. Mower
4
1
3
2
3
1903
15. Recheck the front-to-rear slope again; refer to
step 5.
16. When front-to-rear slope is correct, recheck the
side-to-side level of the mower; refer to
Side-to-Side Mower Leveling, page 37.
17. Push the wire onto the spark plug.