8
1
Figure 5
1.
Lift chain
4. Install canvas ring around the lip on the Versa Vac and
deck openings (Fig. 6).
1
Figure 6
1.
Canvas ring
5. Connect hydraulic motor hose quick couplers to the
Versa Vac couplers as shown in figures 7.
Note: Verify rotation of fingers. Fingers should rotate
clockwise (as viewed from motor end of deck).
1
2
3
Figure 7
1.
Motor hose –front
2.
Motor hose –center
3.
Motor hose –rear
Note: If deck is not level when it is raised off the ground,
reposition lift chain in another mounting hole in bracket.
Before Operating
Note: Determine the left and right sides of the machine
from the normal operating position.
Check Tire Pressure
The correct tire pressure for the castor wheels is 30 psi.
Adjust Operating Height
1. Remove the clevis pin from the spindle shaft (Fig. 8).
1
2
2
3
Figure 8
1.
Clevis pin
2.
Spacer
3.
Caster arm
2. Remove or add ”C” shaped spacers to the spindle shaft,
below the castor arm, to get the desired height.
3. Place all remaining spacers on the spindle shaft above
the caster arm.
4. Install the clevis pin to secure the assembly.
5. Ensure that all four castor wheels are set at the same
height.
