53
Preparation after Storage
Taking this vehicle out of storage and
correctly preparing it will assure many
miles and hours of trouble-free riding.
Toro recommends the following proce-
dure.
1. Clean the vehicle thoroughly.
2. Clean the engine. Remove the cloth
from the exhaust system.
3. Check all control wires and cables for
signs of wear or fraying. Replace if
necessary.
4. Change the engine/transmission oil
and filter.
5. Check the coolant level and add prop-
erly mixed coolant as necessary.
6. Charge the battery; then install. Con-
nect the battery cables making sure to
connect the positive cable first.
7. Check the entire brake systems (fluid
level, pads, etc.), all controls, head-
lights, taillight, brakelight, and head-
light aim; adjust or replace if
necessary.
8. Check the tire pressure. Inflate to rec-
ommended pressure as necessary.
9. Tighten all nuts, bolts, cap screws,
and screws making sure all calibrated
nuts, cap screws, and bolts are tight-
ened to specifications.
10. Make sure the steering moves freely
and does not bind.
11. Check the spark plug. Clean or
replace as necessary.
12. Follow the recommendations found
in the pre-start inspection.
CAUTION
Before installing the battery, make
sure the ignition switch is in the OFF
position.
