42
3. If thickness of either brake pad is less
than 1.0 mm (0.039 in.), take the
vehicle to an authorized Toro ROV
dealer to have brake pads replaced.
PR376B
4. Install the wheel; then using a criss-
cross pattern, tighten the wheel nuts in
27 N-m (20 ft-lb) increments to the
final torque shown in the table below.
PR941A
Protective Rubber
Boots
The protective boots should be inspected
before each use.
Ball Joint Boots (Upper
and Lower/Right and Left)
CC791
1. Secure the vehicle on a support stand
to elevate the front wheels.
2. Remove both front wheels.
3. Inspect the four ball joint boots for
cracks, tears, or perforations.
4. Check the ball joint for free-play by
grasping the steering knuckle and
turning it from side to side and up and
down.
5. If boot damage is present or ball joint
free-play seems excessive, contact an
authorized Toro ROV dealer for service.
Tie Rod Boots (Inner and
Outer/Right and Left)
CC792
1. Secure the vehicle on a support stand
to elevate the front wheels.
2. Remove both front wheels.
3. Inspect the four tie rod boots for
cracks, tears, or perforations.
4. Check the tie rod end free-play by
grasping the tie rod near the end and
attempting to move it up and down.
5. If boot damage is present or tie rod end free-
play seems excessive, contact an authorized
Toro ROV dealer for service.
Steel Wheel
54 N-m
(40 ft-lb)
Aluminum Wheel (Black Nuts)
80 N-m
(60 ft-lb)
Aluminum Wheel (Chrome Nuts) 108 N-m
(80 ft-lb)
CAUTION
Using an impact wrench could result
in incorrect torque which could dam-
age the wheel or hub studs.
