Driving the Machine
Use the traction controls to move the machine. The
farther you move the traction controls in any direction,
the faster the machine moves in that direction.
Release the traction controls to stop the machine.
The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Run the
engine at high throttle for best performance. You
can, however, use the transport speed control in the
InfoCenter to operate the machine at lower speeds
and retain full engine speed; refer to
Maximum Transport Speed (page 16)
.
Shutting Off the Engine
1.
Park the machine on a level surface and lower
the loader arms.
2.
Disengage the auxiliary hydraulics.
3.
Set the throttle to low idle.
4.
If the engine has been working hard or is hot, let
it idle for 5 minutes before turning the key switch
to the O
FF
position.
Note:
This helps to cool the engine before you
shut it off. In an emergency, you can shut off
the engine immediately.
5.
Turn the key switch to the O
FF
position and
remove the key.
CAUTION
A child or untrained bystander could attempt
to operate the traction unit and be injured.
Remove the key from the key switch when
leaving the traction unit, even if just for a few
seconds.
Using Attachments
This is a multipurpose machine intended for use in
various activities. It is designed to operate safely
with a variety of Toro-manufactured attachments,
each of which performs a specialized function. Toro
accepts no liability for machine damage or personal
injury that results from the use of other manufacturers
attachments. The user accepts the burden of these
risks.
Read the attachment
Operator’s Manual
before you
use the attachment.
Important:
Attachments can change the stability
and the operating characteristics of the machine.
Installing an Attachment
Important:
Before installing the attachment,
ensure that the mount plates are free of any dirt or
debris and that the pins rotate freely. If the pins
do not rotate freely, grease them.
1.
Position the attachment on a level surface with
enough space behind it to accommodate the
machine.
2.
Rotate the quick-attach levers outward to raise
the quick-attach pins (
g215372
Figure 28
1.
Quick-attach lever
2.
Attachment mount plate
3.
Start the engine.
4.
Tilt the attachment mount plate forward.
5.
Position the mount plate into the upper lip of the
attachment receiver plate (
).
g215373
Figure 29
1.
Mount plate
2.
Receiver plate
6.
Raise the loader arms while tilting back the
mount plate at the same time.
23
