5
Installing the Handle
Parts needed for this procedure:
1
Handle
2
Flange-head bolts (5/16 x 3/4 inch)
Procedure
1.
Remove the rear access cover; refer to you
traction unit
Operator’s Manual
for instructions.
2.
Locate and drill 2 holes—9.5 mm (3/8 inch
diameter) on the control panel below the loader
arm lever, as shown in
.
g004403
Figure 8
1.
22 mm (55/64 inch)
3.
51 mm (2 inches)
2.
146 mm (5-3/4 inches)
4.
Drill—9.5 mm (3/8 inch)
diameter holes
3.
Secure the handle to the control panel using 2
flange-head bolts (5/16 x 3/4 inch) installed from
the inside (Figure 9).
g004404
Figure 9
1.
Handle
3.
Flange-head bolt (5/16 x
3/4 inch)
2.
Control panel
4.
Install the rear access cover.
7
Summary of Contents for TX Platform
Page 10: ...Notes...
Page 11: ...Notes...
