g006591
Figure 27
1.
Cover
3.
Air-filter base
2.
Foam pre-filter and paper
filter
4.
Remove the foam pre-filter from the paper filter
(
), and replace the paper filter if it is
excessively dirty.
Important:
Do not try to clean a paper filter.
5.
Wash the foam pre-cleaner with a mild detergent
and water, then blot it dry.
Note:
Do not add oil to the foam pre-cleaner.
6.
Install the foam pre-cleaner onto the paper filter.
7.
Install the air-filter assembly.
8.
Install the cover.
Changing the Engine Oil
Service Interval:
After the first 5 hours—Change the
engine oil without the oil filter.
Every 50 hours—Change the engine oil (more
often in dusty conditions).
Note:
Run the engine a few minutes before changing
the oil to warm it. Warm oil flows better and carries
more contaminants.
Engine Oil Specifications
Engine oil capacity
0.65 L (22 fl oz) without oil
filter; 0.85 L (29 fl oz) with oil
filter
Oil viscosity
SAE 30 or SAE 10W-30
detergent oil
API service classification
SJ or higher
1.
Move the machine to a level surface.
2.
Refer to
Maintenance Safety (page 17)
.
3.
Remove the dipstick by rotating the cap
counterclockwise and pulling it out (
g194742
Figure 28
1.
Full
3.
Low
2.
High
4.
Tip the machine onto its side (so that the air
filter is up) to drain the used oil from the oil-fill
tube (
).
18
