Adjusting the Height of Cut
The machine is equipped with a foot pedal deck lift
system. The operator can use the foot pedal to lift
the deck briefly to avoid obstacles or lock the deck in
the highest height-of-cut or transport position. The
operator can use the height of cut lever with the foot
pedal to lock the deck in a specific cutting height.
Using the Foot Pedal Deck Lift System
Press the pedal down to raise the deck; continue to
press the pedal until the deck is locked in the transport
position Figure 24. Push on the deck lift pedal with
your foot and raise the height-of-cut lever slightly to
disengage the transport lock.
G010016
G010219
Figure 24
Transport Lock Position
Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 1-1/2 to
4-1/2 inch (38 to 114 mm) in 1/4 inch (6 mm)
increments by relocating the clevis pin into different
hole locations.
1. Push on the deck lift pedal with your foot and raise
the mower deck to the transport position (also
the 4-1/2 inch (114 mm) cutting height position)
(Figure 25).
2. To adjust, remove the pin from the height-of-cut
bracket (Figure 25).
3. Select a hole in the height-of-cut system
corresponding to the height-of-cut desired and,
insert the pin (Figure 25).
4. Push on the deck lift pedal with your foot and raise
the height-of-cut lever slightly to disengage the
transport lock. Lower the deck slowly until the pin
makes contact with the lever.
G010236
1
2
3
4
5
Figure 25
1.
Deck lift pedal
4.
Lock position. lowest
height-of-cut (use only for
deck removal)
2.
Cut height pin
5.
Lock position. transport
position
3.
Height-of-cut positions
Using the Lock Positions
The deck can be locked in the highest height-of-cut or
transport position or the lowest height-of-cut position.
1. Push on the deck lift pedal with your foot and raise
the mower deck to the transport position (also
the 4.5 inch (114 mm) cutting height position)
(Figure 25).
2. Remove the pin from the height-of-cut bracket
(Figure 25).
3. Select a hole on the lock decal and insert the pin
(Figure 25).
4. Push on the deck lift pedal with your foot and raise
the height-of-cut lever slightly to disengage the
transport lock. Lower the deck to slowly until the
pin makes contact with the lever.
23
Summary of Contents for TITAN ZX6050
Page 11: ...117 1164 1 Fuel 2 Full 3 Half 4 Empty 11...
Page 53: ...Schematics G012083 Wire Diagram Rev A 53...
Page 54: ...Notes 54...
Page 55: ...Notes 55...
