G008748
3/4
1
2
3
4
5
6
Figure 51
1. Apply a thin coat of oil on the surface of the rubber
seal of each filter.
2. Turn the filter clockwise until rubber seal contacts
the filter adapter then tighten the filter an additional
3/4 to 1 full turn. Repeat for the other filter
3. Install the filter guards over each filter as previously
removed. Use the three screws to secure the filter
guards.
4. Slowly pour the specified oil through expansion
reservoir until oil comes out of vent plug holes. Stop
and install the vent plugs. Torque plugs to 180 in-lb
(20.3 N-m).
5. Continue to add oil until it reaches the FULL COLD
line on the expansion reservoir. Proceed to the
Bleeding the Hydraulic System section.
Important:
Failure to perform the
Bleeding
the Hydraulic System
procedure after changing
hydraulic filters and oil can result in irreparable
damage to the transaxle drive system.
Bleeding the Hydraulic System
1. Raise the rear of machine up and support with jack
stands (or equivalent support) just high enough to
allow drive wheels to turn freely.
G010333
1
Figure 52
1.
Jacking points
2. Start engine and move throttle control ahead to 1/2
throttle position. Disengage parking brake.
A. Move the bypass levers into the pushing the
machine position; refer to the Pushing the
Machine by Hand section in Operation. With
the bypass valves open and the engine running,
slowly move the motion control levers in both
forward and reverse (5 or 6 times).
B. Move the bypass levers into the operating
the machine position. With the bypass valve
closed and the engine running, slowly move the
directional control in both forward and reverse
directions (5 to 6 times).
C. Stop the engine and check the oil level in the
expansion reservoir. Add the specified oil as
until it reaches the FULL COLD line on the
expansion reservoir.
3. Repeat step 2 until all the air is completely purged
from the system.
When the transaxle operates at normal noise levels
and moves smoothly forward and reverse at normal
speeds, then the transaxle is considered purged.
4. Check the oil level in the expansion reservoir one
last time. Add the specified oil as until it reaches
the FULL COLD line on the expansion reservoir
if necessary.
40
Summary of Contents for TITAN ZX6050
Page 11: ...117 1164 1 Fuel 2 Full 3 Half 4 Empty 11...
Page 53: ...Schematics G012083 Wire Diagram Rev A 53...
Page 54: ...Notes 54...
Page 55: ...Notes 55...
