Toro TITAN ZX6020, Operator'S Manual, Page: 27 / 60

Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
While sitting in the operator's position, raise the seat
adjustment lever slightly and move the seat forward or
backward to the desired position (Figure 30).
G010232
1
Figure 30
1. Adjustment lever
Adjusting the Motion Control
Levers
Adjusting the Height
The motion control levers can be adjusted higher or lower for
maximum operator comfort.
1. Remove the 2 bolts and 2 washers holding the control
lever to the control arm shaft (Figure 31).
2. Move the control lever to the next set of holes. Secure
the lever with the 2 bolts and 2 washers (Figure 31).
4
1
2
G014970
3
Figure 31
1. Control arm shaft 4. Washer
2. Control lever 5. Bolt
3. Slotted, upper hole
3. Repeat the adjustment for the opposite control lever.
Adjusting the Tilt
The motion control levers can be tilted forward or backward
for maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control arm shaft.
2. Loosen the lower bolt just enough to allow the control
lever to pivot forward or backward.
3. Align the control levers to the new position.
4. Tighten both bolts to secure the control lever position.
5. Repeat steps 1, 2, 3 and 4 to adjustment for the other
control lever.
27