Toro TITAN ZX6020, Operator'S Manual, Page: 25 / 60

Stopping the Machine
To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the blade
control switch (PTO), and turn the ignition key to off.
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake (page 21). Remember to remove
the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Adjusting the Height of Cut
The machine is equipped with a foot pedal deck lift system.
The operator can use the foot pedal to lift the deck briefly to
avoid obstacles or lock the deck in the highest height-of-cut
or transport position. The operator can use the height of
cut lever with the foot pedal to lock the deck in a specific
cutting height.
Using the Foot Pedal Deck Lift System
•
Press the pedal down to raise the deck; continue to press
the pedal until the deck is locked in the transport position
(Figure 27).
•
Push on the deck lift pedal with your foot and raise the
height-of-cut lever slightly to disengage the transport lock
(Figure 27).
G010219
Figure 27
Transport Lock Position
Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 114 mm (1-1/2
to 4-1/2 inch) in 6 mm (1/4 inch) increments by relocating
the height-of-cut pin into different hole locations.
1. Push on the deck lift pedal with your foot and raise the
mower deck to the transport position (also the 114 mm
(4-1/2 inch) cutting height position) (Figure 28).
2. To adjust, remove the pin from the height-of-cut
bracket (Figure 28).
3. Select a hole in the height-of-cut system corresponding
to the height-of-cut desired and insert the pin
(Figure 28).
25