Toro Titan MyRide 75311, Operator'S Manual

Page: 46 / 52

Replacing the Grass
Deflector
Service Interval: Before each use or daily—Inspect
the grass deflector for damage.
WARNING
An uncovered discharge opening could allow
the machine to throw objects toward you or
bystanders, resulting in serious injury. Also,
contact with the blade could occur.
Never operate the machine unless you install
a mulch plate, discharge deflector, or grass
collection system.
1. Disengage the spring from the notch in the
deflector bracket and slide the rod out of the
welded deck brackets, spring, and discharge
deflector (
Figure 68 ).
g297555
Figure 68
1. Rod 4. Deck brackets
2. Spring 5. Spring installed over the
rod
3. Deflector
2. Remove the damaged or worn discharge
deflector.
3. Position the new discharge deflector with the
bracket ends between the welded brackets on
the deck as shown in
Figure 69 .
4. Install the spring onto the straight end of the rod.
5. Position the spring on the rod as shown in Figure
69 so that the shorter spring end comes from
under the rod before the bend and going over
the rod as it returns from the bend.
6. Lift the loop end of the spring and place it into
the notch on the deflector bracket (
Figure 69 ).
g297573
Figure 69
1. Rod and spring assembly
installed 3. Rod, short end, moved
behind the mower bracket
2. Loop end of the spring
installed into the notch in
the deflector bracket 4. Short end, retained by
mower bracket.
7. Secure the rod and spring assembly by twisting
it so that the short end of the rod is behind the
front bracket welded to the deck (
Figure 69 ).
Important:
The grass deflector must be
spring loaded in the down position. Lift the
deflector up to test that it snaps to the full
down position.
46