Toro Titan MyRide 75311, Operator'S Manual

Page: 44 / 52

Leveling the Mower Deck
1. Set the anti-scalp rollers to the top holes or
remove them completely for this procedure; refer
to
Adjusting the Anti-Scalp Rollers (page 24) .
2. Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
Adjusting the Height of Cut
(page 24) .
3. Place 2 blocks, each having a thickness of 6.6
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets (
Figure 64 ).
4. Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck (
Figure 64 ).
g297501
Figure 64
1. Wood block—6.6 cm
(2-5/8 inches) thick 3. Front edge
2. Wood block—7.3 cm
(2-7/8 inches) thick
5. Loosen the adjustment bolts on all 4 corners so
that the deck is sitting securely on all 4 blocks
(
Figure 65 ).
g297515
Figure 65
1. Deck-lift arm
3. Hook
2. Chain 4. Adjustment bolt
6. Ensure that there is tension on all 4 chains
(
Figure 65 ).
7. Tighten the 4 adjustment bolts ( Figure 65 ).
8. Ensure that the blocks fit snugly under the deck
skirt and that all bolts are tight.
9. Verify that the deck is level by checking the
side-to-side level and front-to-rear blade slope;
repeat the deck leveling procedure if necessary.
44