Toro Titan MyRide 75311, Operator'S Manual

Page: 37 / 52

g297596
Figure 45
1. Battery cover 2. Fasteners
4. Disconnect the negative (black) ground cable
from the battery post (
Figure 46 ).
Note:
Retain all fasteners.
5. Slide the rubber cover up the positive (red)
cable.
6. Disconnect the positive (red) cable from the
battery post (
Figure 46 ).
Note:
Retain all fasteners.
7. Remove the battery hold-down ( Figure 46 ), and
lift the battery from the battery tray.
g297597
Figure 46
1. Battery 5. Positive (+) battery post
2. Negative (–) battery post 6. Terminal boot
3. Bolt, washer, and nut for
the negative (–) battery
post 7. Battery hold-down
4. Bolt, washer, and nut for
the positive (+) battery
post
Charging the Battery
Service Interval: Before storage—Charge the battery
and disconnect the battery cables.
1. Remove the battery from the chassis; refer to
Removing the Battery (page 36) .
2. Charge the battery for a minimum of 1 hour at
6 to 10 A.
Note:
Do not overcharge the battery.
3. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (
Figure 47 ).
g000538
Figure 47
1. Positive (+) battery post 3. Red (+) charger lead
2. Negative (–) battery post 4. Black (–) charger lead
Installing the Battery
1. Position the battery in the tray ( Figure 46 ).
2. Using the fasteners previously removed, install
the positive (red) battery cable to the positive
(+) battery terminal.
3. Using the fasteners previously removed, install
the negative battery cable to the negative (-)
battery terminal.
4. Slide the red terminal boot onto the positive
(red) battery post.
5. Secure the battery with the hold-down ( Figure
46 ).
6. Install the battery cover by pushing down and
tightening the 2 fasteners clockwise (
Figure 45 ).
37