Toro titan mx, Service Manual

Page: 30 / 108

CHASSIS
3-10 Toro TITAN 2014 Service Manual
3
Fuel Tank Installation (MX Shown)
1. Position the fuel tank assembly into the unit frame.
2. Install the (2) bolts and nuts (C) that secure the
seat support to the frame brackets and torque to
specification – 17 ft-lbs. (23 Nm).
3. Install the fuel tank retaining rod (B) and torque
retaining bolt to specification – 8 ft-lbs. (11 Nm). Be
sure the front rod end is engaged into the control
box assembly (Fig. 015).
Fig. 014 PICT-3016
Fig. 015 PICT-2069
Fuel Tank Service
Fuel Tank Removal (MX Shown)
1. Raise seat and disconnect battery terminals
2. Remove the RH and LH pod / fender as shown in
this chapter.
3. Remove the (2) bolts that secure the hydro
expansion tank (A) to the seat support. Move the
tank rearward for fuel tank removal clearance.
4. Remove the (1) fastener securing the fuel tank
retaining rod (B) and remove it from the chassis.
5. Remove the (2) bolts and nuts (C) that secure the
seat support to the frame brackets.
6. Note the location of and remove any cable ties /
loom clamps securing wiring / cables to the seat
support bar.
7. Disconnect and properly secure the fuel / vent line(s)
from the top of the fuel tank assembly
8. Remove the seat support bar from the frame.
9. The fuel tank is now loose and can be removed from
the unit frame.
(Fig. 014)
4. Install the (2) bolts (A) that secure the hydro
expansion tank to the seat support and torque to
specification – 5 ft-lbs. (7 Nm).
5. Properly route cables / wiring and reinstall cable ties
/ loom clams to secure them to the seat support.
6. Properly route and reconnect the fuel / vent line(s).
Note: The fuel tank is labeled “FUEL” for the fuel
hose fitting connection and “VENT” for the
fuel tank vent fitting connection.
7. Install the RH and LH pod / fender as outlined in this
chapter.
8. Connect the battery cables and lower seat.
9. Verify proper function.
B
C C A A
B