Premaintenance
Procedures
Service-Interval Chart
Figure 32
Located on the seat pan underside
1.
Read the
Operator's Manual
before performing any
maintenance.
4.
Check the hydraulic oil every 25 hours.
2.
Check the engine oil every 8 hours.
5.
Check the caster wheel tire pressure every 25 hours.
3.
Check the drive wheel tire pressure every 25 hours.
6.
Lubricate the caster wheel every 25 hours.
Raising the Seat
Ensure that the motion-control levers are locked in the
N
EUTRAL
-L
OCK
position and lift the seat forward.
The following components can be accessed by raising the seat:
•
Service decal
•
Fuses
•
Battery and cables
Lubrication
Greasing the Bearings
Service Interval:
Every 25 hours—Grease all lubrication
points.
Grease Type:
No. 2 lithium grease
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Move the motion-control levers outward to the
N
EUTRAL
-L
OCK
position, shut off the engine, remove
the key, and wait for all moving parts to stop before
leaving the operating position.
3.
Clean the grease fittings (
and
) with
a rag.
Note:
Make sure to scrape any paint off the front of
the fitting(s).
29
Summary of Contents for TITAN 74891
Page 52: ...Schematics Wire Diagram Rev A 52...
Page 53: ...Notes 53...
Page 54: ...Notes 54...
Page 55: ...Notes 55...
