Toro TITAN 74891, Operator'S Manual

Page: 19 / 56

Operating the Ignition Switch
1. Turn the ignition key to the S
TART
position ( Figure 14 ).
Note:
When the engines starts, release the key.
Note:
Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
ST
ART
RUN
ST
OP
G008947
Figure 14
2. Turn the ignition key to the S
TOP
position.
Starting and Stopping the
Engine
Starting the Engine
Start the engine as shown in Figure 15 .
Note:
A warm or hot engine may not require choking.
Important:
Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow a 15
second cool-down period between attempts. Failure to
follow these instructions can burn out the starter motor.
Note:
If the fuel system was depleted of fuel—add fuel to
the machine and use additional starting cycles when starting
the engine.
g028223
B A
D
C
F E
S
TA
R
T
R
U
N
S
TO
P
H
G
Figure 15
Stopping the Engine
CAUTION
Injury can occur if children or bystanders move
or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.
Stop the engine as shown in Figure 16 .
19