Toro TITAN 74861, Operator'S Manual

Page: 33 / 60

g028105
Figure 33
1. Air-cleaner cover 2. Air-cleaner latch
3. Remove the foam and paper elements ( Figure
34 ).
4. Remove the foam element from the paper
element (
Figure 34 ).
g028106
Figure 34
1. Air-cleaner cover 3. Paper element
2. Foam element
Servicing the Foam Element
1. Wash the foam element in warm water and
detergent.
2. Rinse and allow it to air dry.
3. Lightly oil the foam element with new oil and
squeeze out excess oil.
Servicing the Paper Element
1. Gently tap the paper element to dislodge dirt.
Note:
Do not wash the paper element or use
pressurized air, as this will damage the element.
Note:
Replace a dirty, bent, or damaged
element. Handle the new element carefully;
do not use if the sealing surfaces are bent or
damaged.
2. Clean the air-cleaner base as required, and
check the condition.
Installing the Elements
1. Install the foam element onto the paper element.
2. Install the elements onto the air-cleaner base
(
Figure 34 ).
3. Install the cover, and secure it with the latches
(
Figure 33 ).
Servicing the Engine Oil
Oil Type: Detergent oil (API service SJ or higher)
Crankcase Capacity: 1.9 L (64 oz) when the filter
is changed
Viscosity: See the table below.
g017552
Figure 35
Checking the Engine-Oil Level
Service Interval: Before each use or daily—Check
the engine-oil level.
1. Park the machine on a level surface, disengage
the blade-control switch, stop the engine, and
remove the key.
2. Make sure the engine is stopped, level, and is
cool, so the oil has time to drain into the sump.
3. Check the engine-oil level ( Figure 36 ).
33