Toro TimeMaster 21810, Manual

Page: 21 / 144

Bagging the Clippings
Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the mower, remove it before bagging the clippings; refer to Removing the
Side-Discharge Chute (page 20) .
Installing the Grass Bag
1. Raise and hold up the rear deflector (A of Figure 24 ).
2. Remove the rear-discharge plug by pulling down on the latch with your thumb and pulling the plug out
from the machine (B of
Figure 24 ).
3. Install the bag rod into the notches at the base of the handle and rock the bag back and forth to ensure
that the rod is seated at the bottom of both notches (C of
Figure 24 )
4. Lower the rear deflector until it rests on the grass bag.
g244854
Figure 24
Removing the Grass Bag
To remove the bag, reverse the steps in Installing the Grass Bag (page 19) .
Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
If the bag is on the machine, remove it and insert the
rear-discharge plug; refer to
Removing the Grass Bag
(page 19) before side-discharging the clippings.
Important:
Ensure that the rear-discharge plug is
in place before you recycle the clippings ( Figure
23 ).
Installing the Side-Discharge
Chute
Unlatch and lift up the side deflector and install the
side-discharge chute (
Figure 25 ).
g235646
Figure 25
19