Form No. 3363-807 Rev A
TimeCutter™ Riding Mowers
Model No. All models
Setup Instructions
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Set up the motion control levers.
2
No parts required
–
Connect the battery.
Ignition Key
1
Hose coupling
1
Operator’s Manual
1
Engine Operator’s Manual
1
3
Operator Training Material
1
Complete the Setup.
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Setting Up the Motion Control Levers
No Parts Required
Procedure
1. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch) as shown in Figure 1.
Raise the motion control levers.
2. Align the holes in the motion control lever with the holes in the control arm shaft and install the bolt and washer
removed previously (Figure 1). Hand tighten all fasteners. Repeat this for both controls levers.
Figure 1
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Summary of Contents for TimeCutter
Page 4: ......
