Toro TimeCutter ZS 4200TF, Operator'S Manual

Page: 21 / 48

G008953
Figure 20
To go straight, apply equal pressure to both motion
control levers (Figure 20).
To turn, release the pressure on the motion control
lever toward the direction you want to turn.
To stop, push the motion control levers to neutral.
Stopping the Machine
To stop the machine, move the motion control levers to
neutral and outward to the park position, disengage the blade
control switch, ensure the throttle is in the fast position, and
turn the ignition key to Off. Remember to remove the key
from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion control levers outward to the park position
when leaving the machine unattended, even if just
for a few minutes.
Adjusting the Height of Cut
Height-of-cut is controlled by the lever located to the right of
the operating position (Figure 21).
1
2
3
g018668
Figure 21
1. Height-of-cut lever 3. 4.5 inch (115 mm),
Transport position
2. Height-of-cut positions
1. Pull up and inward on the lever to move it to the
desired cutting position.
2. Once at the desired cutting position, slowly lower the
lever until it engages the position.
The transport position is the highest height-of-cut position or
cutting height
4.5 inch (114 mm) (Figure 21).
Positioning the Seat
1. Raise the seat and loosen the adjustment bolts just
enough that seat can move (Figure 22).
G 014477
1
Figure 22
1. Adjustment bolt
2. Move the seat to the desired position and tighten the
bolts.
21