Toro TimeCutter ZD420, Operator'S Manual

Page: 22 / 52

Removing the Collection Chute
As you are bagging, a small amount of grass
clippings normally blow out the front of the
mower. An excessive amount of clippings blowing
out and no audible alarm signalling a full bag may
indicate a plugged chute.
The collection chute can be removed to be cleaned
and safely cleared of any obstructions. Use the
following procedure to remove it:
1. Make sure the collection bag is empty.
2. Park the machine on a level surface and
disengage the blade control switch.
3. Move the motion control levers to the brake
position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving
the operating position. Raise the operator’s
seat.
4. Move to the rear of the machine and remove
the collection bag.
5. Grasp the discharge chute and remove as
follows.
Important:
Use caution and do not use
excessive force when removing/installing
the chute. “Forcing” the chute can damage
it or other internal components.
A. Pull the chute out from the machine
approximately 6-8 inches (15-20 cm).
B. Rotate the chute a quarter turn downward
and proceed to pull chute out further to
expose the first bend.
C. With the bend exposed rotate the chute a
quarter turn counter clockwise.
D. Pull the chute until the key is visible. Line
the key in the chute with the keyway.
E. Remove the chute.
Figure 18
22