Figure 59
1.
Cover
2.
Screw
5.
Using a spring removal tool, (Toro Part No. 92-5771),
remove the idler spring from the deck hook to remove
tension on the idler pulley and roll the belt off the
pulleys (
and
WARNING
The spring is under tension when installed
and can cause personal injury.
Be careful when removing the belt.
g017639
1
2
3
3
5
4
6
7
7
Figure 60
Mower Decks with 2 Blades
1.
Idler pulley
5.
Engine pulley
2.
Mower belt
6.
Spring-removal tool
3.
Outside pulley
7.
Mower-deck handles
4.
Spring
G014931
1
2
3
3
4
5
6
Figure 61
Mower Decks with 3 Blades
1.
Idler pulley
4.
Spring
2.
Mower belt
5.
Engine pulley
3.
Outside pulley
6.
Spring-removal tool
6.
Route the new belt around the engine pulley and
mower pulleys (
and
7.
Using a spring removal tool, (Toro Part No. 92-5771),
install the idler spring over the deck hook and placing
tension on the idler pulley and mower belt (
and
).
8.
Install the pulley covers (
).
Installing the Mower
1.
Park the machine on a level surface and disengage the
blade-control switch.
2.
Engage the parking brake, shut off the engine, remove
the key, and wait for all moving parts to stop before
leaving the operating position.
3.
Slide the mower under the machine.
4.
Lower the height-of-cut lever to the lowest position.
5.
Lift the rear of the mower deck and guide the hanger
brackets over the rear lift rod (
).
6.
Attach the front support rod to the mower deck with
the clevis pin and hairpin cotter (
).
7.
Install the mower belt onto the engine pulley; refer to
Replacing the Mower-Deck Belt (page 43)
.
44
