g014635
Figure 56
1.
Front support rod
3.
Deck bracket
2.
Locking nut
5.
Using the mower deck handles, lift the mower
deck and hanger brackets clear of the rear lift
rod and lower the mower carefully to the ground
(
and
).
g005077
Figure 57
1.
Mower deck
3.
Rear lift rod
2.
Hanger bracket
6.
Slide the mower deck rearward to remove the
mower belt from the engine pulley.
7.
Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
Mower Belt Maintenance
Inspecting the Belts
Service Interval:
Every 25 hours—Check the belts
for wear/cracks.
Check the belts for cracks, frayed edges, burn marks,
or any other damage. Replace damaged belts.
Replacing the Mower Belt
Squealing when the belt is rotating, blades slipping
when cutting grass, frayed belt edges, burn marks,
and cracks are signs of a worn mower belt. Replace
the mower belt if any of these conditions are evident.
1.
Park the machine on a level surface and
disengage the blade-control switch.
2.
Ensure that the parking brake is engaged,
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Set the height of cut at the lowest cutting position
of 38 mm (1-1/2 inches).
4.
Using a spring-removal tool, (Toro Part No.
92-5771), remove the idler spring from the deck
hook to remove tension on the idler pulley, and
roll the belt off the pulleys (
and
WARNING
The spring is under tension when
installed and can cause personal injury.
Be careful when removing the belt.
45
Summary of Contents for TimeCutter SW 5000
Page 52: ...Schematics g027754 Electrical Diagram Rev A 52 ...
Page 53: ...Notes ...
Page 54: ...Notes ...
Page 55: ...Notes ...
