Figure 42
1.
Positive battery post
3.
Red (+) charger lead
2.
Negative battery post
4.
Black (-) charger lead
Installing the Battery
1.
Position the battery in the tray (
2.
Install the positive (red) battery cable to the positive (+)
battery terminal using the fasteners removed previously.
3.
Install the negative battery cable to the negative (-)
battery terminal using the fasteners removed previously.
4.
Slide the red terminal boot onto the positive (red)
battery post.
5.
Secure the battery with the hold-down (
6.
Lower the seat.
Servicing the Fuses
The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Fuse:
•
Main F1-30 amp, blade-type
•
Charge Circuit F2-25 amp, blade-type
1.
Remove the screws securing the control panel to the
machine. Retain all fasteners
2.
Lift the control pane up to access the main wiring
harness and fuse block (
).
3.
To replace a fuse, pull out on the fuse to remove it
(
).
30
25
30
25
G014921
2
1
Figure 43
1.
Main-30 amp
2.
Charge circuit-25 amp
4.
Return the control panel to its original position. Use
the screws removed previously to secure the panel to
the machine.
34
