Toro TimeCutter SS 4250, Operator'S Manual

Page: 20 / 48

Adjusting the Height-of-Cut
Note:
The transport position is the highest height-of-cut
position or cutting height (115 mm (4.5 inches)) as shown
in
Figure 19 .
Height-of-cut is controlled by the lever located to the right of
the operating position (
Figure 19 ).
Figure 19
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so the rollers do not touch
the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Adjust the anti-scalp rollers to one of the following
positions:
•
Upper hole—use this position with the mower deck
in the 63mm (2-1/2 inch) and below height-of-cut
positions (
Figure 20 ).
•
Lower hole—use this position with the mower
deck in the 76mm (3 inch) and above height-of-cut
positions (
Figure 20 ).
g019929
1
2
3
4
5
Figure 20
1. Anti-scalp roller 4. Upper hole—the mower
deck in the 63mm
(2-1/2 inch) and below
height-of-cut positions
2. Lower hole—the mower
deck in the 76mm (3 inch)
and above height-of-cut
positions 5. Bolt
3. Flange Nut
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
g027249
B
C
A
Figure 21
20