Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the height
of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers do not
touch the ground in normal, flat mowing areas.
1.
Disengage the blade-control switch (PTO), move the
motion-control levers to the P
ARK
position, and set the
parking brake.
2.
Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3.
Adjust the anti-scalp rollers to 1 of the following
positions:
•
Upper hole—use this position with the mower
deck in the 63 mm (2-1/2 inch) and below the
height-of-cut positions (
Figure 18
).
•
Lower hole—use this position with the mower deck
in the 76 mm (3 inch) and above the height-of-cut
positions (
Figure 18
).
g019929
1
2
3
4
5
Figure 18
1.
Anti-scalp roller
4.
Upper hole—the mower
deck in the 63mm (2-1/2
inch) and below the
height-of-cut positions
2.
Lower hole—the mower
deck in the 76mm (3
inch) and above the
height-of-cut positions
5.
Bolt
3.
Flange nut
Positioning the Seat
Move the seat forward or backward as shown in
Figure 19
.
g027249
B
C
A
Figure 19
Adjusting the Motion-Control
Levers
Adjusting the Height
You can adjust the motion-control levers higher or lower for
maximum comfort (
Figure 20
).
g027252
B
A
Figure 20
21
Summary of Contents for TimeCutter SS 4225
Page 49: ...Schematics Electrical Diagram Rev A 49 ...
Page 50: ...Notes 50 ...
Page 51: ...Notes 51 ...
