Toro TimeCutter HD ZX4800, Operator'S Manual

Page: 24 / 56

3. Select a hole in the height-of-cut system
corresponding to the desired height of cut and
insert the pin (
Figure 26 ).
4. Push on the deck-lift pedal with your foot and
pull the handle rearward to disengage the
transport lock (
Figure 25 ).
5. Lower the deck slowly until the lever makes
contact with the pin.
g188850
Figure 26
1. Deck-lift pedal 3. Pin
2. Handle 4. Height-of-cut positions
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake; refer to
Engaging the Parking Brake
(page 18) .
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in Figure
27 .
g029955
Figure 27
1. Anti-scalp roller 4. Flange nut
2. Spacer 5. Bolt
3. Bushing
Using Attachments and
Accessories
Use only Toro approved attachments and accessories.
If you attach a bucket to the engine guard, use a strap
to secure it.
Important:
The bucket weight impacts the
stability of the machine. If you are carrying more
than the weight listed in the table below in a
bucket attached to the engine guard, you must
equip your machine with the Bucket-Support Kit.
Contact your Authorized Service Dealer.
Model Maximum weight per bucket
without the Bucket-Support
Kit
48-inch deck 1.1 kg (2.5 lb)
54-inch deck
1.1 kg (2.5 lb)
60-inch deck 4.5 kg (10 lb)
24