Keeping the Underside of the Mower
Clean
Clean clippings and dirt from the underside of the mower
after each use. If grass and dirt build up inside the mower,
cutting quality will eventually become unsatisfactory.
Maintaining the Blade(s)
Maintain a sharp blade throughout the cutting season because
a sharp blade cuts cleanly without tearing or shredding the
grass blades. Tearing and shredding turns grass brown at
the edges, which slows growth and increases the chance of
disease. Check the mower blades after each use for sharpness,
and for any wear or damage. File down any nicks and sharpen
the blades as necessary. If a blade is damaged or worn, replace
it immediately with a genuine Toro replacement blade.
After Operation
After Operation Safety
General Safety
•
Clean grass and debris from the cutting units, mufflers,
and engine compartment to help prevent fires. Clean up
oil or fuel spills.
•
Shut off the fuel before storing or transporting the
machine.
•
Disengage the drive to the attachment whenever you are
transporting or not using the machine.
•
Use full-width ramps for loading the machine into a
trailer or truck.
•
Tie the machine down securely using straps, chains, cable,
or ropes. Both front and rear straps should be directed
down and outward from the machine.
•
Allow the engine to cool before storing the machine in
any enclosure.
•
Never store the machine or fuel container where there is
an open flame, spark, or pilot light, such as on a water
heater or on other appliances.
29
Summary of Contents for TimeCutter HD X5450
Page 55: ...Schematics g203461 Electrical Diagram Rev A 55 ...
Page 56: ...Notes ...
Page 57: ...Notes ...
Page 58: ...Notes ...
