Toro TimeCutter 74706, Operator'S Manual

Page: 32 / 56

Pre-Maintenance
Procedures
Raising the Seat
Ensure that the parking brake is engaged. Lift the
seat forward.
You can access following components by raising the
seat:
•
Serial plate
•
Service decal
•
Seat-adjustment bolts (if applicable)
•
Fuel filter
•
Battery and battery cables
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours—Grease all the
lubrication points.
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake; refer to
Park Position (page 13) .
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings ( Figure 27 and Figure
28 ) with a rag.
Note:
Scrape any paint off the front of the
fitting(s).
g032432
Figure 27
1. Front caster tire
decal106-8717
Figure 28
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance 3. Grease every 25 operating
hours
2. Check the tire pressure
every 25 operating hours
4. Engine
4. Connect a grease gun to each fitting ( Figure 27
and Figure 28 ).
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
32