Toro TimeCutter 74502, Operator'S Manual

Page: 23 / 40

23
Installing the Spark Plug
1. Install the spark plug. Make sure that the air gap is set
correctly.
2. Tighten the spark plug to 30 ft.-lb. (41 N
⋅
m).
3. Push the wire onto the spark plug (Fig. 21).
Cutting Blades
Maintain sharp blades throughout the cutting season
because sharp blades cut cleanly without tearing or
shredding the grass blades. Tearing and shredding turns
grass brown at the edges, which slows growth and increases
the chance of disease.
Check the cutter blades daily for sharpness, and for any
wear or damage. File down any nicks and sharpen the
blades as necessary. If a blade is damaged or worn, replace
it immediately with a genuine Toro replacement blade. For
convenient sharpening and replacement, you may want to
keep extra blades on hand.
Danger
A worn or damaged blade can break, and a piece
of the blade could be thrown into the operator’s or
bystander’s area, resulting in serious personal
injury or death.
•
Inspect the blade periodically for wear or
damage.
•
Replace a worn or damaged blade.
Before Inspecting or Servicing the Blades
Park the machine on a level surface, disengage the PTO,
and set the parking brake. Stop the engine, remove the key,
and disconnect the spark plug wire(s) from the spark
plug(s).
Inspecting the Blades
1. Inspect the cutting edges (Fig. 23). If the edges are not
sharp or have nicks, remove and sharpen the blades;
refer to Sharpening the Blades, page 24.
2. Inspect the blades, especially the curved area (Fig. 23).
If you notice any damage, wear, or a slot forming in this
area (item 3 in Fig. 23), immediately install a new
blade.
1
2
3
m–151
Figure 23
1. Cutting edge
2. Curved area
3. Wear/slot forming
Checking for Bent Blades
1. Stop the engine, set the parking brake, remove the key,
and disconnect the spark plug wire(s) from the spark
plug(s).
2. Rotate the blades until the ends face forward and
backward (Fig. 24). Measure from a level surface to the
cutting edge of the blades (Fig. 25). Note this
dimension.
Front
m–1078
Figure 24
MEASURE FROM
CUT TING EDGE TO A
LEVEL SURFACE
m–2539
Figure 25
3. Rotate the opposite ends of the blades forward. Measure
from a level surface to the cutting edge of the blades at
the same position as in step 2 above. The difference
between the dimensions obtained in steps 2 and 3 must
not exceed 1/8 in. (3 mm). If this dimension exceeds
1/8 in. (3 mm), the blade is bent and must be replaced;
refer to Removing the Blades and Installing the Blades,
page 24.