g003235
Figure 38
4.
Remove the blade, saving all mounting
hardware.
5.
Install the new blade and all mounting hardware.
Important:
Position the curved ends of the
blade to point toward the machine housing.
6.
Use a torque wrench to tighten the blade bolt
to 82 N-m (60 ft-lb).
Important:
A bolt torqued to 82 N-m (60
ft-lb) is very tight. While holding the blade
with a block of wood, put your weight
behind the ratchet or wrench and tighten the
bolt securely. This bolt is very difficult to
overtighten.
Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1.
Turn the adjustment knob counterclockwise to
loosen the cable adjustment (
).
g027709
Figure 39
1.
Handle (left side)
3.
Self-propel-drive cable
2.
Adjustment knob
2.
Adjust the tension on the cable (
) by
pulling it back or pushing it forward and holding
that position.
Note:
Push the cable toward the engine to
increase the traction; pull the cable away from
the engine to decrease the traction.
3.
Turn the adjustment knob clockwise to tighten
the cable adjustment.
Note:
Tighten the knob firmly by hand.
19
Summary of Contents for Super Recycler 20382
Page 23: ...Notes ...
