Toro Super Recycler 20382, Operator'S Manual

Page: 18 / 72

Servicing the Air Cleaner
Service Interval: Before each use or daily
Yearly
1. Press down on the latch tabs on top of the air
cleaner cover (
Figure 33 ).
g002902
Figure 33
1. Latch tabs
2. Open the cover.
3. Remove the paper air filter ( Figure 34 ).
g027630
Figure 34
4. If the air filter is damaged or is wet with oil or
fuel, replace it.
5. If the air filter is dirty, tap it on a hard surface
several times or blow compressed air less than
207 kPa (30 psi) through the side of the filter
that faces the engine.
Do not brush the dirt off the filter; brushing forces
dirt into the fibers.
6. Remove dirt from the air cleaner body and cover
using a moist rag.
Do not wipe dirt into the
air duct.
7. Install the filter into the air cleaner.
8. Install the cover.
Changing the Engine Oil
Service Interval: After the first 5 hours
Yearly
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
1. Perform the pre-maintenance procedures; refer
to
Preparing for Maintenance (page 16) .
2. Remove the dipstick.
3. Tip the machine onto its side, with the dipstick
down, to drain the used oil out through the oil-fill
tube (
Figure 35 ).
g017485
Figure 35
4. After draining the used oil, return the machine to
the normal operating position.
5. Remove the dipstick and pour about 3/4 of the
crankcase capacity of oil into the oil-fill tube.
Note:
Max. fill: 0.55 L (18.6 oz), type: SAE 30
or SAE 10W-30 detergent oil with an API service
classification of SF, SG, SH, SJ, SL, or higher.
6. Wipe off the dipstick end with a clean cloth.
7. Insert the dipstick into the oil-fill tube.
8. Remove the dipstick and read the oil level on
the dipstick (
Figure 36 ).
17