Toro Super Bagger, Operator'S Manual

Page: 18 / 104

After Operation
After Operation Safety
General Safety
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Remove the ignition key (if equipped) before
loading the machine for hauling.
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.
Cleaning under the Machine
Service Interval: After each use
For best results, clean under the machine soon after
you have completed mowing.
1. Lower the machine to its lowest cutting-height
setting.
2. Move the machine onto a paved level surface.
3. With the engine running and the blade engaged,
spray a stream of water in front of the
right , rear
wheel ( Figure 37 ).
Note:
The water will splash into the path of the
blade, cleaning out the clippings.
g002600
Figure 37
4. When no more clippings come out, stop the
water and move the machine to a dry area.
5. Run the engine for a few minutes to dry the
underside of the machine.
Folding the Handle
Upright Position
1. Step on the foot pedal and hold it down ( Figure
38 ).
g002773
Figure 38
2. Move the handle to the upright position ( Figure
39 ).
g020809
Figure 39
Forward Position
1. With the handle in the upright position, step on
the foot pedal and hold it down.
2. Move the handle all the way forward and loosen
the upper handle knob (
Figure 40 ).
g010273
Figure 40
17