). Refer to your local ordinances for trailer and
tie-down requirements.
g013180
Figure 19
1.
Front tie-down loop
g013181
Figure 20
1.
Rear tie-down loops
Lifting the Machine
You can lift the machine using the tie-down/lift loops
as lift points (
and
Operating Tips
•
Clean the area of trash, branches, and rocks
before operating to prevent equipment damage.
•
Always use full throttle (maximum engine speed)
when grinding.
•
Cut the edges of the stump for more efficient
grinding. Once your cutting swath is close to 1/4
of the wheel diameter, lower the grinder and begin
cutting on the edge again.
g013671
Figure 21
•
Listen to the engine and watch the grinder wheel
speed to maintain the speed of the wheel. Slow
down the head sweep by feathering the joystick as
cutting becomes difficult.
•
As you grind from left to right, most of the debris
goes to the left of the grinder wheel. When you
grind from the right to left, the debris goes to the
right.
•
You may also grind a stump from the side to lessen
turf damage.
19
Summary of Contents for STX-26
Page 43: ...Schematics g013418 Electrical Schematic Rev A 43...
Page 44: ...g025169 Hydraulic Schematic Rev A 44...
Page 45: ...Notes...
Page 46: ...Notes...
