Toro SS 4200, Operator'S Manual

Page: 47 / 56

4. Carefully rotate the blade(s) so they are facing
front to rear (
Figure 60 and Figure 61 ).
g014631
Figure 60
Mower Decks with 1 Blade
1. Blade front to rear
2. Measure from the tip of the blade to the flat surface here.
g009658
Figure 61
Mower Decks with 2 Blades
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here.
5. Measure from the tip of the front blade to the flat
surface, and the tip of the rear blade to the flat
surface (
Figure 60 and Figure 61 ).
Note:
If the front blade tip is not 1.6 to 7.9 mm
(1/16 to 5/16 inch) lower than the rear blade tip,
adjust the front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (
Figure
62 ).
g014634
Figure 62
1. Adjusting rod 3. Locknut
2. Adjusting block
7. To raise the front of the mower, tighten the
adjustment nut.
8. To lower the front of the mower, loosen the
adjustment nut.
9. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip (
Figure 60 and
Figure 61 ).
10. When the front-to-rear blade slope is correct,
check the side-to-side level of the mower again;
refer to
Leveling from Side to Side (page 45) .
47