Toro SMRT Logic SMRT-I Quick Reference & Setup Manual Download Page 4

LED Behavior

Cause

Solution

 

steady orange

SMRT Logic unable to 

get an IP address from 

the network’s DHCP 

server.

Confirm the network is configured to assign IP addresses. If 

needed, a SMRT Logic can be manually configured to use 

a static IP address. Refer to Advanced SMRT Logic network 

setup on the website.

 

blinks green

SMRT Logic unable to 

reach the internet.

Confirm there is a valid internet connection using the same 

Ethernet wire if possible.

Troubleshooting

FCC Statement - FCC ID: OF7SCG

This device complies with Part 15 of the FCC Rules. Operation is subject 

to the following two conditions: (1) This device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

In order to maintain compliance with the FCC RF exposure guidelines, 

this device should be installed and operated with a minimum distance of 

20cm between the radiator, and the body of the operator and/or nearby 

persons.

Any change or modification not approved by the party responsible for 

compliance could void the user’s authority to operate this device.

Permitted Low Gain Dipole Whip Antenna (2dBi).

IC Statement - IC: 3575A-SCG

1. Under Industry Canada regulations, this radio transmitter may only 

operate using an antenna of a type and maximum (or lesser) gain 

approved for the transmitter by Industry Canada. To reduce potential 

radio interference to other users, the antenna type and its gain should be 

so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not 

more than that necessary for successful communication.

Conformément à la réglementation d’Industrie Canada, le présent 

émetteur radio peut fonctionner avec une antenne d’un type et d’un 

gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie 

Canada. Dans le but de réduire les risques de brouillage radioélectrique 

à l’intention des autres utilisateurs, il faut choisir le type d’antenne et 

son gain de sorte que la puissance isotrope rayonnée équivalente 

(p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une 

communication satisfaisante.

2. This radio transmitter  has been approved by Industry Canada 

to operate with the antenna types listed below with the maximum 

permissible gain and required antenna impedance for each antenna type 

indicated. Antenna types not included in this list, having a gain greater 

than the maximum gain indicated for that type, are strictly prohibited for 

use with this device.

Le présent émetteur radio (identifier le dispositif par son numéro de 

certification ou son numéro de modèle s’il fait partie du matériel de 

catégorie I) a été approuvé par Industrie Canada pour fonctionner avec 

les types d’antenne énumérés ci-dessous et ayant un gain admissible 

maximal et l’impédance requise pour chaque type d’antenne. Les types 

d’antenne non inclus dans cette liste, ou dont le gain est supérieur au 

gain maximal indiqué, sont strictement interdits pour l’exploitation de 

l’émetteur.

Antenna Approved/Antenne approuvé
Type/Type

Max. Gain/Max. Gain

Impedance/Impédance

Dipole Whip

2.0 dBi

50 Ω

3. This device complies with Industry Canada licence-exempt RSS 

standard(s). Operation is subject to the following two conditions: (1) this 

device may not cause interference, and (2) this device must accept any 

interference, including interference that may cause undesired operation 

of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada 

applicables aux appareils radio exempts de licence. L’exploitation est 

autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas 

produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout 

brouillage radioélectrique subi, même si le brouillage est susceptible d’en 

compromettre le fonctionnement.

4. In order to maintain compliance with the IC RF exposure guidelines, 

this device should be installed and operated with a minimum distance of 

20 cm between the radiator, and the body of the operator and/or nearby 

persons.

Afin de maintenir la conformité avec les directives d’exposition RF IC, 

ce dispositif doit être installé et exploité avec une distance minimale 

de 20 cm entre le radiateur et le corps de l’opérateur ou à proximité de 

personnes.

FCC and IC Statements

Specifications

Model Name:  SMRT Logic

Model Number:  SMRT-T, SMRT-I

Dimensions:  4.4” x 3.1” x 1.2” without antenna

Unit Weight: 3.4oz (95g) without accessories

Certification:  FCC, IC, UL-Listed Power Adapter

Power:  5Vdc, 1A

Port Speed:  10/100 Mbps

Operating Temp: 32 to 104°F (0-40°C)

Storage Temp: -4 to 140°F(-20 to 60°C)

Operating Humidity:  10 to 80% RH, non-condensing

Go Mobile

4

Download the SMRTscape app for Apple iOS or 

Android to control your irrigation system.

How It Works

Reviews: