Toro Reelmaster 5610-D, Owner'S Manual

Page: 43 / 84

g224398
Figure 77
Important:
Perform a parked regeneration
to restore the PTO function; refer to Preparing
to Perform a Parked or Recovery Regeneration
(page 43)
and Performing a Parked or Recovery
Regeneration (page 44) .
Note:
The Home screen displays the PTO disabled
Icon ( Figure 78 ).
g224415
Figure 78
Recovery Regeneration Messages
When a recovery regeneration is requested by the engine
computer, the following messages display in the InfoCenter:
•
Engine warning SPN 3719, FMI 0 ( Figure 79 )
g213867
Figure 79
•
Recovery regeneration required—power takeoff
disabled A
DVISORY
#190 ( Figure 80 )
g224399
Figure 80
Important:
Perform a recovery regeneration to
restore the PTO function; refer to Preparing to Perform
a Parked or Recovery Regeneration (page 43) and
Performing a Parked or Recovery Regeneration (page
44)
.
Note:
The Home screen displays the PTO disabled Icon;
refer to Figure 78 in Parked Regeneration Messages (page
42) .
DPF Status-Limitation
•
If the engine computer requests a recovery regeneration
or is processing a recovery regeneration and you scroll
down to the P
ARKED
R
EGEN
option, parked regeneration
locks and the lock icon ( Figure 81 ) appears in the lower
right corner of the InfoCenter.
g224625
Figure 81
•
If the engine computer has not requested a recovery
regeneration and you scroll down to the R
ECOVERY
R
EGEN
option, the recovery regeneration locks and the
lock icon ( Figure 82 ) appears in the lower right corner
of the InfoCenter.
g224628
Figure 82
Preparing to Perform a Parked or Recovery
Regeneration
1. Ensure that the machine has fuel in the tank for the
type of regeneration you are performing:
•
Parked Regeneration: Ensure that you have
1/4 tank of fuel before performing the parked
regeneration.
•
Recovery Regeneration: Ensure that you have
1/2 tank of fuel before performing the recovery
regeneration.
2. Move the machine outside to an area away from
combustible materials.
3. Park the machine on a level surface.
4. Ensure that the traction control or motion-control
levers are in the N
EUTRAL
position.
5. If applicable, shut off the PTO, and lower the cutting
units or accessories.
43