Toro Reelmaster 5510 Series, Service Manual

Page: 85 / 662

Installing the Fuel Tank
1. Install the fuel tank to the frame ( Figure 35 ). Secure the fuel hoses with the
cable ties as recorded during the fuel tank removal.
g188097
Figure 36
1. Fuel sender 2. Fuel supply fitting 3. Fuel return fitting
2. If the fuel sender was removed from the fuel tank, ensure that the fuel fittings
on the sender are orientated at 90° from right side of the tank as shown in
Figure 36 . Torque the fuel sender cap to 20 to 22 N∙m (175 to 200 in-lb) and
ensure that the fuel sender does not turn as the sender cap is tightened.
3. Connect the fuel supply and return (items 17 and 2 in Figure 35 ) hoses to
the fittings on the top of the fuel sender. Secure the fuel hoses with the hose
clamps.
4. Secure the wire harness connector to the fuel sender.
5. Connect the negative battery cable to the negative battery post.
6. Ensure that the fuel tank draincock is closed. Fill the fuel tank with clean fuel.
7. Prime the fuel system; refer to Priming the Fuel System (page 4–23) .
8. Check the fuel hoses and fittings for leaks.
Note: Repair all fuel leaks before returning the machine to service.
9. Lower the hood and secure it with the latches.
Reelmaster ® 5410/5510/5610 Series Page 4–25 Yanmar Diesel Engine: Service and Repairs
15216SL Rev C