Toro Reelmaster 5510 Series, Service Manual

Page: 571 / 662

Assembling the Cutting Reel (Cutting Unit with Aluminum Side Plates) (continued)
IMPORTANT
The flocked seal should be installed so that the flocked (red) side of
the seal is toward the bearing location.
5. Slide the flocked seals (flocked (red) side orientated toward bearing location)
and bearings fully onto the reel shaft. Flocked seals and bearings should
bottom on reel shaft shoulder.
6. Fill threaded insert splines with high temperature Mobil XHP-222 grease
or equivalent.
Preparing the Reel for Grinding
g230299
Figure 347
1. Blade land width 3. Scalloped radial reel 5. Tapered forward sweep reel
2. Blade relief angle 4. Tapered radial reel
g230300
Figure 348
Reel diameter taper = D1 - D2
Reelmaster ® 5410/5510/5610 Series Page 9–41 Cutting Unit: Service and Repairs
15216SL Rev C